Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#76155 by Bob Urbanek
Mon Apr 01, 2019 12:14 pm
I have never used automatic dimension before. The first time I tried it, it picked up points that didn't exist. On subsequent attempts, it only picks up the beginning and endpoints and nothing in between. Is there a setting somewhere that I'm missing?

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984