Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#76155 by Bob Urbanek
Mon Apr 01, 2019 12:14 pm
I have never used automatic dimension before. The first time I tried it, it picked up points that didn't exist. On subsequent attempts, it only picks up the beginning and endpoints and nothing in between. Is there a setting somewhere that I'm missing?

Who is online

Users browsing this forum: No registered users and 39 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984