forum.datacad.com

when I use the 2d3d casework template or the 3d stairs,
and try to go to elevations or the hide command, all I get is a single line.
This is only on one drawing that I'm working on. However,
I tried to copy those cabinets to another drawing that
worked with the 3d stairs. When i hit elevations, they still
came up a straight line.
I'm sure there is a setting that i hit and can not find.
Any suggestions.
Thanks
Robert " Butch Berry
architect
Eureka Springs, AR .

1. Maybe check the Projection Pad has Ortho (Plan view) selected as it could be set to a 3D view such as Parallel/Iso etc.?
2. Also turn off any clipcubes that may be on.
3. Identify the line and if it is "hundreds of kilometres" long, delete it, then regen the drawing.