Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#77820 by Bob Urbanek
Fri Apr 03, 2020 2:27 pm
My drawing crashed. Got the message "internal diagnostic fault 39" Can not open aec , arb, or arf file. Any help would be appreciated.
#77821 by Mark Bell
Fri Apr 03, 2020 5:48 pm
See if you can locate a $wp swap file (also look in the temporary files etc.). If you find it, copy and paste and rename it and see if you can open it.
If you have an earlier version of DataCAD see if that can open any of the files you have (it might sound unusual, but I had something similar a while back where the file couldn't be opened in the latest DataCAD but could using an earlier version!)

Who is online

Users browsing this forum: No registered users and 33 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984