Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#78450 by esme103
Tue Jul 28, 2020 11:50 pm
I have been using Datacad for quite a while but really only use the 2D capacity. For some reason I am currently having trouble adding in doors. I know I need to put the door in a 2 line wall and I have to either choose the layer the wall is on or select "any layer". I go to the Architect list and choose "Door". I am directed to choose the hinge side, which I do, but then I am not asked to select the strike side and the door does not get drawn. Can you suggest something I might try or that I am suddenly doing wrong.
In advance, thanks for the help.
#78451 by Roger D
Wed Jul 29, 2020 9:14 am
Old walls or new 3d versions?
is layer locked?
are z base/height within the same area?
If old 2d, are they 2d walls? Identify and check the wall attribute, if I recall 2d walls were 57. Draw a new 2d wall to check what is should be.

Who is online

Users browsing this forum: No registered users and 50 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984