Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#78708 by gringojosh
Tue Sep 08, 2020 10:26 am
I usually use a 1/4" or 1/2" grid snap. Often I will set the grid size and snap, only to have grid snapping turn off later when I am drawing. I then have to go back and reset the grid snap. I use "X" for grid snap and "alt-X" for measures. It doesn't seem to be related to accidental keystrokes, etc. Is there any way to fix it so I don't have to keep going back and resetting the grid snap distance? Any idea what could be causing this?

Who is online

Users browsing this forum: No registered users and 33 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984