Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#79038 by George W. Burns CPBD
Wed Nov 11, 2020 3:55 pm
I am using alt-x (measure) then S.5 (area/per) to get square footage on a plan. No matter if I choose cont. search, rectangle, or both unchosen to trace around the perimeter (my preferred method of course), I keep getting 0 sq. ft. and 0 cubed feet. I dooooo get the perimeter measurement though. Could this be a setting? Or is it more likely a corrupted file?

Who is online

Users browsing this forum: No registered users and 89 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984