Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#80377 by Bob Urbanek
Mon Nov 01, 2021 6:28 pm
This may be a simple fix, but I can't find it. Opened up an old drawing in V19, tried to edit it. Tried to install a symbol, and it comes in at a huge scale.Same thing with any symbol. Tried to fix it in the browser but no luck.How do I fix this? I tried opening the drawing in V22, but got the same result.
Thanks, Bob
#80378 by joshhuggins
Mon Nov 01, 2021 6:35 pm
While inserting the symbol, check if Symbol Scale is turned on if you do not have your symbols setup to use Symbol Scale.
#80379 by Bob Urbanek
Mon Nov 01, 2021 6:46 pm
Thanks for the reply, Josh. I have tried it with symbol scale on and off . Also symbol scale by folder on and off. Tried both on and off too? Can't figure it out.
Bob
#80380 by Roger D
Mon Nov 01, 2021 6:49 pm
Is the enlargement set to more than one?

Who is online

Users browsing this forum: No registered users and 41 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984