I think the line you are looking for is farther down in the file
Clip Cubes||Set specific 3D boundary of model to display
do a search for "clip cubes"
Roger Donaldson AIA CSI CDT NCARB
abUsing Datacad since 1986, ver 23.00.01.02 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 23.00.01.02 (SE)
http://www.RogerDonaldsonArchitect.com
Okay possibly - but that might be a 3D Clip Cube. I need to edit X-Clips.
you might be correct, I tried adding a shortcut and it doesn't show.
Has to be somewhere in that file I would think
Has to be somewhere in that file I would think
Roger Donaldson AIA CSI CDT NCARB
abUsing Datacad since 1986, ver 23.00.01.02 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 23.00.01.02 (SE)
http://www.RogerDonaldsonArchitect.com
David A. Giesselman
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
That works! Thanks Dave; and you were correct Roger.
David A. Giesselman
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Senior Vice President & CTO
DATACAD LLC
dave@datacad.com
Providing thoughtfully crafted, software bugs to the DataCAD community since 1984.
Who is online
Users browsing this forum: No registered users and 41 guests