Hello
I am new to DataCad 20 . If you have a drawing with 40 light fixtures existing on a drawing, and each is a pre defined block (light fixture) that has been previously inserted,
and you want to revise all 40 fixtures with one operation and change say size, color, layer, (etc) how is this easily done with DataCad?
In Autocad REFEDIT command would do this. But in DataCad how is this easily done?
With DataCad can you make a custom toolbar and place the most common commands used on a new toolbar, and locate on the work area at a convenient place?
Thanks in advance. H. Hampton
I am new to DataCad 20 . If you have a drawing with 40 light fixtures existing on a drawing, and each is a pre defined block (light fixture) that has been previously inserted,
and you want to revise all 40 fixtures with one operation and change say size, color, layer, (etc) how is this easily done with DataCad?
In Autocad REFEDIT command would do this. But in DataCad how is this easily done?
With DataCad can you make a custom toolbar and place the most common commands used on a new toolbar, and locate on the work area at a convenient place?
Thanks in advance. H. Hampton