Hi,
We recently got a change (I think) in the way that 1-Line Trim works. The top lines in the DcadWin.INI [General] section:
My 1-Line trim shortcut is:
With the 2 $ symbols at the end, it used to pick the trim line, and the outside - but it no longer works. How do I get it working again?
We recently got a change (I think) in the way that 1-Line Trim works. The top lines in the DcadWin.INI [General] section:
Code: Select all
1LineTrim By Entity=
; Controls the behavior of the Entity toggle in 1LnTrim.
; If TRUE, Entity is automatically reset to on.
; If FALSE, Entity is automatically reset to off.
; If blank, the Entity toggle will retain its last status.
My 1-Line trim shortcut is:
Code: Select all
Y^;^F9^F4^$^$^
//1-Line Trim
With the 2 $ symbols at the end, it used to pick the trim line, and the outside - but it no longer works. How do I get it working again?