Use this forum to ask questions about DataCAD 20 and DataCAD LT 20.
#75086 by Neil Blanchard
Fri Oct 26, 2018 10:06 am
Hi,

We recently got a change (I think) in the way that 1-Line Trim works. The top lines in the DcadWin.INI [General] section:

Code: Select all1LineTrim By Entity=
; Controls the behavior of the Entity toggle in 1LnTrim.
; If TRUE, Entity is automatically reset to on.
; If FALSE, Entity is automatically reset to off.
; If blank, the Entity toggle will retain its last status.


My 1-Line trim shortcut is:

Code: Select allY^;^F9^F4^$^$^
//1-Line Trim


With the 2 $ symbols at the end, it used to pick the trim line, and the outside - but it no longer works. How do I get it working again?
#75087 by Roger D
Fri Oct 26, 2018 10:38 am
I use
Q^;^1016#^F9^F4^$^$^
\\ Q- Trim to one line, 1016-One Line Trim by Entity On

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984