Eric Murray wrote:What am I doing wrong? Maybe the problem is in the grouping of the four segments or the original ellipse below.
You'll need to trace over the entire ellipse by creating one polyline. In Curves, Polyline...
- Rectangle should be toggled Off
- Closed should be toggled On
- Covered should be Off for Hatching (On for 3D Modeling)
- Object Snap to the endpoint of one of the arcs
- Select 2 Pt. Arc
- Object Snap to the center point of the arc you're about to draw
- Toggle Clockwise On or Off as needed
- Object Snap to the end point of the arc you're drawing
- You'll be prompted "Click center of arc"
- Continue by repeating these steps drawing four arcs until you get to the first point where you started
- Right-click to finish the polyline
- You should now have 1 elliptical-shaped polyline