Page 1 of 1


PostPosted: Fri Sep 17, 2021 6:16 pm
by Archer19
I must be having a brain dead event or something.
I have a file that when hatching , select boundary ... the cont. search (f5) is on the selection menu.

But some of my files when selecting hatch, boundary.... only rectangle is on the selection menu.
no Cont. Search????? where did it go? how do I get it back on? what did I turn off?

Totally lost, that file in my brain must be corrupted.

Re: Hatching

PostPosted: Tue Sep 28, 2021 1:54 pm
by Joseph Baron
Did you get this resolved?
If not, is it possible for you to share an AEC file that exhibits this behavior?