Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#80803 by CDAVIS
Tue Apr 12, 2022 12:53 pm
I'm working on an L-shaped plan, but the two legs of the plan are not at 90-degrees from each other.

So, the one leg is not square (it's actually at 92.969-degrees).

Is it possible to toggle between the standard angle and an alternate angle, so I can draw with straight lines and not offset every line?
#80806 by Joseph Baron
Tue Apr 12, 2022 1:37 pm
Here's a keyboard macro that allows you to select the line to set tangent to, then run again to reset to 0. Ortho should be ON.

^:^f6^f4^f3^$^

Who is online

Users browsing this forum: No registered users and 12 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984