Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#76121 by Mark Bell
Wed Mar 27, 2019 5:27 am
Hi Seasdes,

1. Have your drawing on the screen and zoom extents,
2. Go to Print/MultiLayout/Layout - this displays a MSP sheet ready for you to place the drawing info onto,
3. Pick S2 Rotate, enter an angle (say 90'), and move your crosshair onto the sheet, left mouse-click to place and enter a detail name to finish, - done.
4. If you toggle S5 Extents Only, this will show either a bounding box or the actual drawing info you're placing on the screen, depending whether it's on of off,
Hope this helps.
#76140 by seasdes
Wed Mar 27, 2019 10:09 pm
Thanks Mark.
I was trying to rotate the drawing 8 deg 20 min in a clockwise direction.
I was following your instructions and I couldn't get the rotation angle correct.
In a moment of madness I tried adding a minus figure in front of the angle (ie -8.20.00) and all seems to rotate as I would have expected.
Thanks again.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984