Page 1 of 1
Text alignment
Posted:
Thu Jun 27, 2019 8:34 amby John Daglish
What tools can you use in Datacad to align vertically separate blocks of text - in simple text and/or mtext and/or paratext ?
An option in move to align all the blocks of text vertically would be handy.
Re: Text alignment
Posted:
Thu Jun 27, 2019 8:54 amby Roger D
You are asking to align or justify to a left line?
That would be in Text/Justify, draw the vertical line, then you can pick the justify option (left/center/right), then pick the text.
Re: Text alignment
Posted:
Fri Jun 28, 2019 3:03 pmby John Daglish
Thanks,
Re: Text alignment
Posted:
Sat Jun 29, 2019 10:21 pmby Mark Bell
1. If using standard Alt+T to enter text dynamically onto the screen, you can also turn on the text insertion point (Tools/Program Preferences/Drawing/Display Options which allows you to draw a vertical/horizontal line to then move the text into alignment.
2. Using GetSnap (shift + o/snap) saves having to draw any line,
3. If you turn off the T in SWOTHLUDFBK this will only display text as an outline allowing you to align them.