Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#76599 by Bob Kreger
Sun Jun 30, 2019 8:21 am
I just want to middle-button snap, not be offered choices as Get-Snap does. Any suggestions appreciated.
#76600 by joshhuggins
Sun Jun 30, 2019 1:54 pm
You probably have inference snapping enabled, which changes the middle button to Get Snap since your single left click would be used for snapping based on the Dynamic Snapping settings. You can turn off Inference Snapping in the Program Preferences, Drawing tab under Dynamic Snapping. With Inference Snapping off, middle click will be normal snapping once again SHIFT+Middle Click will bring up the Get Snap menu when needed.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984