Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#76784 by Lars
Wed Jul 24, 2019 12:58 pm
I'm having an issue with Line To Poly. When I convert a set of lines, the result skips control points and even creates its own. Can I change the sensitivity of Line To Poly so it accepts each line/curve endpoint as part of the polyline? Starting Line To Poly from different line segments produces a different result, however, it always leaves out 3 control points. Is there a limit that I can raise?
Attachments
linetopoly.PNG
After
linetopoly.PNG (9.61 KiB) Viewed 397 times
lines.PNG
Before
lines.PNG (9.13 KiB) Viewed 397 times
#76788 by Mark Bell
Wed Jul 24, 2019 5:59 pm
Have you tried using the contour search instead, which would also be quicker allowing you to just 'touch' the inside of the line work to generate the polyline?
#76799 by artmanvt2000
Fri Jul 26, 2019 10:12 am
Another option would to be select the option "KeepLins" (Keep Lines). After the polyline is created, you can and points as needed to pick up the missing points and lines.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984