forum.datacad.com

I'm having an issue with Line To Poly. When I convert a set of lines, the result skips control points and even creates its own. Can I change the sensitivity of Line To Poly so it accepts each line/curve endpoint as part of the polyline? Starting Line To Poly from different line segments produces a different result, however, it always leaves out 3 control points. Is there a limit that I can raise?

Have you tried using the contour search instead, which would also be quicker allowing you to just 'touch' the inside of the line work to generate the polyline?

Another option would to be select the option "KeepLins" (Keep Lines). After the polyline is created, you can and points as needed to pick up the missing points and lines.