Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#76922 by Lars
Thu Aug 29, 2019 10:54 am
I'm not sure how this happened but all of the sudden, Dir. Distance input does not work for drawing lines. I can input a distance but the direction is preset and will not accept cursor input. Any/every line is now jumping out at an angle that seems to be set from the position between the cursor and absolute zero. (however, the distance is correct.)

What setting might be wrong for this to be the case?

Thanks!

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984