Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77196 by dennisnorton
Tue Nov 05, 2019 3:58 pm
Why can I not change the thickness of a smart wall? I have also tried creating a new wall type, but I am unable to define the thickness of the wall...

Also, as a side note, I can not remove the CMU pattern from the CMU Smart Wall and don't see where the material is specified...

Something strange going on?

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984