forum.datacad.com

Does a macro exist to interrogate wall lines, presuming all the other layers are off, and remove or correct any that are non-linear?
I'm working on a very normal house and found several lines slightly off the basic 90 degree grid; probably a sloppy move or stretch
or something like that. I could see them so corrected it. Thank you.

I have a macro called Right that corrects lines like you mention. I just checked and it appears to do much more than that, but the only thing that I have ever used it for over the years is to correct some slightly out of grid line. Even though it has the normal entity, group... etc. selections, I have always used it for single lines. I'm not sure how it works for numerous selections at one time.
I wish that I knew who the author was so that I could thank him for a really nice tool.
Woody

I've usually avoided macros, but they're handy. Where's a good site to look for third-party macros?

Evan Shu was my go to source. He carried them on Cheap Tricks.