Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#77880 by tlarso
Wed Apr 15, 2020 9:28 pm
I have created some symbols and when I bring them out of the folder I put them in the symbol is about 3/4 the size of the object that it was created from. What can I do to correct this problem? This happens to any symbol I pull out to use, not just the ones I have created. Any help anyone can provide would be appreciated.
#77881 by Roger D
Wed Apr 15, 2020 9:38 pm
After selecting the symbol double-check the enlarged setting, make sure it is 1.0
#77882 by joshhuggins
Wed Apr 15, 2020 10:08 pm
Or check if Symbol Scale is turned on in the Symbol Browsers options or while inserting a symbol in the menu.
#77883 by tlarso
Wed Apr 15, 2020 11:44 pm
Thanks Josh and Roger. I followed your advice and it corrected my problem.

Who is online

Users browsing this forum: No registered users and 12 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984