Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#78702 by Chris
Mon Sep 07, 2020 4:19 pm
I am having a problem with a couple stations NOT running the macros consistently (one that won't run them at all). We have been doing a lot of upgrading to the May 20 version of W10. The Unit that won't run them will NOT allow any paths to be changed in the configure.

Who is online

Users browsing this forum: No registered users and 14 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984