Been going steady for months on version " 21.03.08.00 (PE) ".... (whatever PE is...)
Suddenly the hatch command is crashing the aec file.
I tried using Hatch in a new blank file. It crashed even a new empty aec file.
I even used the File Repair function - no change.
Sounds like I should reinstall DCAD?
Any ideas?
Bob
Suddenly the hatch command is crashing the aec file.
I tried using Hatch in a new blank file. It crashed even a new empty aec file.
I even used the File Repair function - no change.
Sounds like I should reinstall DCAD?
Any ideas?
Bob
Bob Kreger
Kreger Design/Build, LLC
3068 Plaza Blanca
Santa Fe, NM 87507
505-660-9391
kregerdesignbuild@msn.com
Kreger Design/Build, LLC
3068 Plaza Blanca
Santa Fe, NM 87507
505-660-9391
kregerdesignbuild@msn.com