New Year's Resolutions for the Studio.
![Post Post](./styles/BBOOTS/imageset/icon_post_target.gif)
I just decided that one of my tasks for the start of the new year is to redo my master and template drawings for Datacad and Sketch-Up/Layout.. I've recently found that my SU-2015 drawings when they are saved as SU-2021 don't have full functionality in SU-2021. I've just been copying over-and-over my master drawing files for years...and they're accumulating barnacles. And the same for my Datacad master drawings created over the years in Datacad ver-18., some going back to Version-15 or earlier.
Had to replace the PC Tower and hard-drive a few months ago after a catastrophic failure, so fresh software installs both of Sketch-Up 2021 and Datacad-21.
Time for a clean sweep with a new broom.
Had to replace the PC Tower and hard-drive a few months ago after a catastrophic failure, so fresh software installs both of Sketch-Up 2021 and Datacad-21.
Time for a clean sweep with a new broom.