Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#80502 by Ted B.
Thu Dec 16, 2021 12:07 pm
I just decided that one of my tasks for the start of the new year is to redo my master and template drawings for Datacad and Sketch-Up/Layout.. I've recently found that my SU-2015 drawings when they are saved as SU-2021 don't have full functionality in SU-2021. I've just been copying over-and-over my master drawing files for years...and they're accumulating barnacles. And the same for my Datacad master drawings created over the years in Datacad ver-18., some going back to Version-15 or earlier.

Had to replace the PC Tower and hard-drive a few months ago after a catastrophic failure, so fresh software installs both of Sketch-Up 2021 and Datacad-21.

Time for a clean sweep with a new broom.

Who is online

Users browsing this forum: No registered users and 5 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984