Use this forum to ask questions about DataCAD 21 and DataCAD LT 21.
#80672 by Gary24752
Wed Feb 23, 2022 2:04 am
How do you go about setting the default distance for both "z" base and height. I know how to change it but there must be a way of setting it to begin with. I am assuming once that can be set can this be used to figure volumn and if so how or what do you have to do to get that?
#80674 by Roger D
Wed Feb 23, 2022 9:02 am
z

hit the z key, set the z-base, z-height and those settings will continue to be used.
Caution, if you do a Identify, set all, then the z values will be changed to what that entity z's are
#80676 by joshhuggins
Wed Feb 23, 2022 11:50 am
Also, if you create and use base files that have your typical drawing info like borders, typical notes, typical details, etc., you can set your z-base/height in those file to a default value as well so your new projects always start how you prefer.

Who is online

Users browsing this forum: No registered users and 7 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984