Can I toggle between TWO Angles when drawing?
Posted: Tue Apr 12, 2022 12:53 pm
I'm working on an L-shaped plan, but the two legs of the plan are not at 90-degrees from each other.
So, the one leg is not square (it's actually at 92.969-degrees).
Is it possible to toggle between the standard angle and an alternate angle, so I can draw with straight lines and not offset every line?
So, the one leg is not square (it's actually at 92.969-degrees).
Is it possible to toggle between the standard angle and an alternate angle, so I can draw with straight lines and not offset every line?