Topic Title

I'm working on an L-shaped plan, but the two legs of the plan are not at 90-degrees from each other.

So, the one leg is not square (it's actually at 92.969-degrees).

Is it possible to toggle between the standard angle and an alternate angle, so I can draw with straight lines and not offset every line?

Try using Geometry > Tangents to align the snap gird to the existing line.

Here's a keyboard macro that allows you to select the line to set tangent to, then run again to reset to 0. Ortho should be ON.

^:^f6^f4^f3^$^

CDAVIS, did this work for you?