Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#81488 by Mark Bell
Wed Sep 14, 2022 5:21 pm
This is just a stab in the dark here so may not be correct, but a while back the ability to ctrl-right click over an existing dimension and then pick Reposition from the pop-up menu, was added as a new feature. This ini setting may relate to that feature?
#81490 by Joseph Baron
Wed Sep 14, 2022 5:51 pm
Relocate works the same whether that is T or F.

We have visible attributes on dimensions but they don't move when relocate is used so I'm curious to find out what it's supposed to do, the PDF just mentions the INI setting.

Thanks for the reply.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984