Every now and then I get this problem, sometimes it goes away on its own and sometimes it reappears and I am at a loss to prevent it. There has never been an answer to it.
I cannot post the image here as it wont let me but the problem is the xref (floor plans) prints last over the top of the mechanical services layout (ductwork) so instead of having a clean duct line there are gaps in it where the xef prints the light grey lines, which are normally walls, over the top of the ductwork.
I have never had this resolved in over 15 years. It looks so unprofessional.
It's random and seems to be a flaw in DCad because settings are not changed to make it stop or to make it appear again.
Help
I cannot post the image here as it wont let me but the problem is the xref (floor plans) prints last over the top of the mechanical services layout (ductwork) so instead of having a clean duct line there are gaps in it where the xef prints the light grey lines, which are normally walls, over the top of the ductwork.
I have never had this resolved in over 15 years. It looks so unprofessional.
It's random and seems to be a flaw in DCad because settings are not changed to make it stop or to make it appear again.
Help
A bad days fishing is better than a good day in the office.