Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#82291 by suttonarch
Thu Jun 08, 2023 12:53 pm
Batch printing forgets updated GTV layers on clipped xref MSP details.


The MSP sheet shows all the layers are properly on within the details. If I manually print it. It come out good. But when I batch print, some layers are turned off. I've tried updating the GTV and and have GTV on in the Xref. Thanks for any tips.
#82304 by Mark Bell
Sun Jun 11, 2023 8:04 pm
I think this may be an issue identified in the Beta testing that is yet to be resolved? I'm unsure if this is what you have been doing but the only suggestion you could try is to manually update each GTV when any changes have been made prior to changing a view or printing to ensure the GTV is the most current. Also check the path names to xrefs are current.

Who is online

Users browsing this forum: No registered users and 19 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984