Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#79230 by Bob Urbanek
Thu Dec 31, 2020 5:06 pm
Every thing working fine, all of a sudden I get O2C failed to create. Any ideas?
#79232 by Mark Bell
Thu Dec 31, 2020 5:30 pm
I sometimes (rarely) get this happen. Closing and restarting DataCAD seems to fix it. You can also try using File/Purge on the drawing if it persists.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984