Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#79265 by BDCommunityDesign
Fri Jan 15, 2021 10:40 am
I did a repair on a file and now I cannot snap to any points in any drawings so I cannot use my program. I cannot mirror, cannot create a hatch, copy. I have checked all of my snaps are picked, layer snap is on, miss dist is 10, offset is off, more options are off. I have tried copying and pasting into a new drawing, but nothing has helped. It is happening in every drawing I open so it's not just the file. It's the program now. Do I have to reinstall the program?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984