Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#80091 by Roger D
Tue Sep 14, 2021 1:50 pm
There is a delete double command under the 3dMenu, Hide, Options. Then run the hide command on the area. Should work.
#80094 by Joe Krawiec
Wed Sep 15, 2021 8:13 am
I have often wondered about this. At times, I simply go through and delete the line, refresh, repeat. Annoying at best. I just tried using the delete double command, but it doesn't seem to work.

#80209 by Roger D
Fri Oct 01, 2021 8:03 am
Did you have "Save Image" selected and saved to a new layer.
If that didn't work, then the lines must not be exactly the same.
#80211 by Joseph Baron
Fri Oct 01, 2021 11:12 am
Hide does work to remove duplicated lines, using Save Image as Roger pointed out.

I used these settings, in Options with F2 Delete Dbl. & F3 Ignore Color, and Hide F3 Save Image & S5 Active ON, you can get a new layer with duplicated lines removed, and even shorter lines with the same or different Z settings under longer lines get removed.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984