Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#80203 by joshhuggins
Wed Sep 29, 2021 8:04 pm
Back during the release of Off Symbol Layer support, weren't we able to do a symbol edit on a symbol and turn off layers and then write the symbol back to the hard drive and then when we inserted the symbol that the default state of what layers were on/off would match what they were when the symbol was saved? I can't seem to do this now. :?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984