Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#80484 by DBrennfoerder
Tue Dec 14, 2021 3:54 pm
V 22.00.08.01 (PE)
I used to be able to draw a line across a polygon and one side of that line would be raised or dropped by a specified amount and I could choose the color of the offset. It was great for contour sites or for cutting a street into a site. What was that macro? I can't find it today. Has it gone by the wayside?
#80485 by Mark Bell
Tue Dec 14, 2021 4:52 pm
May be you're describing the TIN Modeller which is built in to the 3D Entity/Polygons/ TIN Surface routine as this allows you to raise/lower 3D polygons to create roads, cut and fill and site contours etc.?

Who is online

Users browsing this forum: No registered users and 12 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984