forum.datacad.com

V 22.00.08.01 (PE)
I used to be able to draw a line across a polygon and one side of that line would be raised or dropped by a specified amount and I could choose the color of the offset. It was great for contour sites or for cutting a street into a site. What was that macro? I can't find it today. Has it gone by the wayside?

May be you're describing the TIN Modeller which is built in to the 3D Entity/Polygons/ TIN Surface routine as this allows you to raise/lower 3D polygons to create roads, cut and fill and site contours etc.?

Yup; that's it. Thanks so much. I haven't used it for years and need it this week. Forgot where y'all hid that one.