Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#80811 by Neil Blanchard
Wed Apr 13, 2022 3:34 pm
Hi folks,

I am working in a file that doesn't keep MSP details in place - they get placed and saved, and they are listed on the menu. but each time a sheet is loaded, it is blank.

Is there something obvious that I am missing? This is a file I just got from someone, and it has been this way for him, too. He upgraded from v19 to v22 and the issue apparently first occurred at that point.

I ran Repair, and some corrupt entities were erased, but it didn't help this issue.
#80844 by Neil Blanchard
Wed Apr 27, 2022 4:20 pm
Hi Mark,

I think that I did check that, yes. This is only occurring is that one file, that I was working in for someone, and the project was halted. So, this is not critical - but I would like to find the cause, so they can continue to use the file in the future.

Who is online

Users browsing this forum: No registered users and 19 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984