forum.datacad.com

Hi folks,

I am working in a file that doesn't keep MSP details in place - they get placed and saved, and they are listed on the menu. but each time a sheet is loaded, it is blank.

Is there something obvious that I am missing? This is a file I just got from someone, and it has been this way for him, too. He upgraded from v19 to v22 and the issue apparently first occurred at that point.

I ran Repair, and some corrupt entities were erased, but it didn't help this issue.

Hi Neil,
Have you checked to see if S9 Show All is selected in the Print/MultiLayout menu?

Hi Mark,

I think that I did check that, yes. This is only occurring is that one file, that I was working in for someone, and the project was halted. So, this is not critical - but I would like to find the cause, so they can continue to use the file in the future.