Either old age is creeping in and the memory is going or maybe this trick doesn't exist in DCAD so it's nothing I have forgotten since my first use of DCAD back in 1985. Is there a way to take a brick wall hatch pattern to alter the X scale only to show how the brick would look in a wall at 45-degrees to the viewer? I have tried removing the associative characteristics of a standard brick pattern to then do an X scale change on the remaining lines but that just explodes the pattern back to a polyline rectangle with no remaining hatch lines.
David Porter AIA
(DataCadder since v.2)
(DataCadder since v.2)