Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#81701 by Neil Blanchard
Thu Oct 27, 2022 12:46 pm
Hi, I like the fact that DataCAD scales down the widths of lines when you do a check plot - this is the only way to do it that makes sense. BUT - for lines that we have on our Pen Table that are already just about as thin as our HP plotter can produce - 0.06mm - when I do a 50% sized sheet, these thinnest lines "disappear" and do not plot.

So, I am hoping that this function of scaling down line widths can have a minimum setting?

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984