Use this forum to ask questions about DataCAD 22 and DataCAD LT 22.
#81720 by Daniel
Mon Nov 07, 2022 1:58 pm
I had a coworker present me with a drawing situation that has left me confounded. He dimensioned and noted his floor plan using the arial font, and at the time everything looked fine. But today when he opened it, the text was just outlined (not filled) and all the text didn't identify as text, but as individual lines and arcs. So, the text cannot be edited. I managed to type new text without any problems. I have never experienced this before, and could not figure out how it could have happened. Any one have any ideas?

Thanks,
Daniel
#81723 by Daniel
Mon Nov 07, 2022 4:02 pm
Thank you, that appears to be it ('explode' on the 3D menu). Now the real mystery was how he applied that to his whole drawing without knowing he did it...I'd rather not go down that road. :lol:

Who is online

Users browsing this forum: No registered users and 29 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984