Topic Title

Was surprised when I just created a ruled surface between 2 contour lines. There are very significant variations between the edges of the created surface (blue in the image below) and the contours (white) ... I would have expected the surface to follow the contours much more closely (the only places they seem to coincide are at the contour nodes).

RuledSurf.png (13.7 KiB) Viewed 4371 times

[Mark F. Madura]

Looks like this was broken sometime after DataCAD 21.

[Mark F. Madura]

Thanks for reporting this David. Fixed for the next build.

Fixed for the next build.

Thanks Mark,
It is working properly when I test it in the latest build (22.02.09.01)