forum.datacad.com

Having a big problem with a drawing. Tried to repair it. In the first window, I chose defaults, and hit OK. Took me to the window that asks for z settings.Also chose defaults. Can't go anywhere from there. What am I missing?

Thanks, Bob

Not much help, but I had the same issue a while back. Not matter the settings I chose; it would just sit a do nothing. I kept trying and finally it just worked. Repairs seem to be a hit and miss if it actually works.

Recently I had problems with a file. So I just opened a new empty file and imported everything from the old file. Then it worked fine.

Thanks Roger, that worked. A few settings changed, but not a problem.
Bob

The one settings that did not get passed through for me was the MSP Sheet Names did not get updated.