Page 1 of 1
Problem with Inc. Angles measure
Posted:
Thu Feb 22, 2024 7:20 amby Aaron Ben-Avraham
I am having a problem with measuring the Inc. angle between 2 lines (measures menu, S1) it always reports 0. If I go to dimensions and dimension angle, it reports the angle correctly. It is only from the measure menu I get the wrong answer. Is anyone else having this problem?
Thanks
Aaron
Re: Problem with Inc. Angles measure
Posted:
Thu Feb 22, 2024 7:36 amby David Porter
I can confirm this. I tried this on a couple of files and different angles between 2 lines. I did restarts of DCAD and of the computer. About every 10th attempt, DCAD would show me the included angle measurement. The other attempts showed the angle to be 0-0 degrees.
Re: Problem with Inc. Angles measure
Posted:
Tue Mar 12, 2024 5:55 pmby Mark F. Madura
Sorry about that. If the lines share an endpoint, the calculation will return an incorrect result of zero. Corrected for the next builds of DataCAD 22 and 23.
Re: Problem with Inc. Angles measure
Posted:
Thu Mar 14, 2024 4:18 pmby Aaron Ben-Avraham
Thanks for the update Mark!