Use this forum to ask questions about DataCAD 23 and DataCAD LT 23.
#83267 by Twizzle
Wed Oct 30, 2024 11:02 pm
I have had this issue for many years through various upgrades, about 20 or so and no one has been able to help me with it.

I import an xref, floor plans in light grey.

All my work is over the top of the xref in 10 or 15 layers and colours. It doesn't matter what the pen table setting are on, print first or last, makes no difference. The only consistent thing is that the layer that I print from prints last, the other layers are partially covered as the xref printed over the top of them.

Pen sort is unchecked, WYWYWIG is checked.

They do not print in order no matter what the setting are, as far as I can tell.

Any advice would be very helpful.
#83268 by Roger D
Thu Oct 31, 2024 7:30 am
I haven't had any issues like that. I do have my xref's near the top in the layers list before any other layers.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984