Post off topic threads here.
#66872 by cgarchitect
Thu Jul 23, 2015 12:19 pm
I use datacad 14 and am helping out a friend with some drawings. I wanted to know how to reset the polar angle so 90 degrees is up and zero degrees is to the right. I use relative polar on all my other drawings and they work correctly. I did change the input to relative input but when I try to input a line at 45 degrees it goes to the left and not right.

How do I change or reset this to the default.

Thanks
Paul
#66873 by MtnArch
Thu Jul 23, 2015 12:26 pm
Paul -

Go to Utility/Settings/Angle Type/Start Angle. Pick your starting point and drag to the right to set the angle to zero.

Who is online

Users browsing this forum: No registered users and 22 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984